Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
www.viveconbienestar.com
REFILLING THE TANK
Do not overfill the unit. If the lower (supply) tank is 1/2 full, do not fill the upper (fill) water tank
than halfway. Overfilling the tank may cause the unit to overflow.
IMPORTANT: The white polymer connector for the wire to the tap assembly is designed to fit in
direction only. If this is disconnected and resistance is felt when reattaching, do not attempt to
into place. Reverse its position to reconnect.
MAINTENANCE
Keep the PiMag
Waterfall
®
Hand wash the water tanks periodically (approximately once a month) to keep them clean and
deposits. You may use a mild detergent or soap. When cleaning the unit, do not use a scrubber
paper towels, which may result in scratches on the surface. Use a soft cloth to dry.
The prefilter may be rinsed or flushed if it becomes discolored or water flow is reduced. Use cold wa
Do not boil the filter cartridge. Clean only by rinsing in cold water.
Component replacement
The replacement filter must be prepared by soaking (preferably for 8 hours) before installation.
steps 3 through 5 as described in the Assembly Instructions in this manual.
• After the water has filled the supply (lower) tank, pull outward on the water tap lever to lift u
locks in the open position, to drain the Waterfall. Fill and drain the unit while the tap is open
two full cycles.
Filter cartridge life will vary, depending on amount of use and water quality.
Recommended replacement for mineral stones at least once per year.
Replacement parts
The following replacement parts may be ordered from Nikken Inc.
Filter cartridge #13845
Mineral stones #13846
TROUBLESHOOTING
Problem : Water has a disagreeable taste or odor.
Cause : Poor water quality or filters need replacing.
Solution : (1) Check quality of water used in system. (2) Clean prefilter pads. (3) Replace filter cartridg
Problem : Reduced water flow through unit.
Cause : Air retained in prefilters.
Solution : Remove all five (5) prefilter pads, compress them by squeezing each one under water
expel air bubbles, replace.
COMPONENT REPLACEMENT REMINDER
To order
these items telephone Nikken Inc. at 1-800-669-8859, or order online at Nikken.com.
Specifications and appearance are subject to change without notice.
Manufactured by Nikken Inc.
2 Corporate Park, Irvine CA 92606
Nihon Kenko Zoushin Kenkyukai, Canada Corp.
6300 Edwards Blvd., Building 2, Mississauga, ON L5T 2X3
www.viveconbienestar.com
Gravity Water System away from direct sunlight.
®
6
Publicité
Table des Matières
