Reversing the Door Swing
Your freezer can be opened from either the right side or the left. By default, the door
hinge is on the right side. If you prefer it on the left, please follow the appropriate
instructions below:
NOTE: All of the parts that are removed must be kept for the reinstallation of the door.
For models VT65M, VT65ML, VT65MBI and VT65MLBI :
1. Upper hinge fastener
2. Lower hinge
3. Kick plate
a. Unscrew the lower hinge and take off the door.
b. Push the kick plate to the right in the new position.
c. Undo the upper hinge fastener and fix it to the opposite side of the housing, where you
have already removed and replaced the fastener with the hole to the opposite side.
d. Put the door on the upper hinge fastener.
e. Fix the lower hinge in the new position.
f. Unscrew the handle and place it on the opposite side.
g. Some screws are covered with caps. Take off these caps before undoing the screws.
h. Check the gasket. It should not be creased and should seal well.
:
4. Handle
5. Door hinge fixture
6. Door hinge fixture plug
8