Before Starting The Equipment - Toolson PRO-WS 900 S Mode D'emploi D'origine

Anleitung_PRO_WS_900_S_SPK7:_
GB

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
5.1 Fitting the additional handle (Fig. 2)
The angle grinder must not be used without the
additional handle (4).
The additional handle can be secured in any of
three positions (A, B, C).
Tool side
Left (position A / as Right-handed users
shown)
Right (position B) Left-handed users
Top (position C) Using cutting wheels
5.2 Setting the guard (Fig. 3)
Switch off the tool. Pull the power plug.
Adjust the guard (5) to protect your hands so that
the material being ground is directed away from
your body.
The position of the guard (5) can be adjusted to
any specific working conditions. Undo the screw
(a) and turn the cover (5) into the required
position.
Ensure that the guard (5) correctly covers the
gear wheel casing.
Retighten the screw (a).
Ensure that the guard (5) is secure.
Take care that the safety device is secure.
Never use the angle grinder without the
guard.
5.3 TEST RUN FOR NEW GRINDING WHEELS
Allow the right-angle grinder to run in idle for at least
1 minute with the grinding or cutting wheel fitted in
place. Vibrating wheels are to be replaced
immediately.
12
13.05.2009 9:04 Uhr
6. Operation
6.1 SWITCH (Fig. 4-5)
The ON/OFF switch (3) has a locking switch (a)
to prevent the tool being started by accident.
To start the equipment push the locking switch
(a) forwards, then press the ON/OFF switch (3).
To lock the switch in the ON position, push the
interlocking switch (a) up to the stop whilst the
ON/OFF switch (3) is pressed, and hold. Once it
is in position, let go of the ON/OFF switch (see
Fig.5).
To switch off, press the ON/OFF switch again.
Suitable for
Wait until the machine has reached its top
speed. You can then position the angle grinder
on the workpiece and machine it.
6.2 Changing the grinding wheels (Fig. 6)
Use the face spanner (6) supplied to change the
grinding wheels.
Pull out the power plug.
Simple wheel change by spindle lock:
Press the spindle lock and allow the grinding
wheel to latch in place.
Open the flange nut with the face spanner.
(Fig. 6)
Change the grinding or cutting wheel and tighten
the flange nut with the face spanner.
Important!
Only ever press the spindle lock when the motor
and grinding spindle are at a standstill!
You must keep the spindle lock pressed while
you change the wheel!
For grinding or cutting wheels up to approx. 3 mm
thick, screw on the flange nut with the flat side facing
the grinding or cutting wheel.
6.3 Flange arrangements when using grinding
wheels and cutting wheels (Fig. 7-10)
Flange arrangement when using a depressed-
centre or straight grinding wheel (Fig. 8)
a) Clamping flange
b) Flange nut
Flange arrangement when using a depressed-
centre cutting wheel (Fig. 9)
a) Clamping flange
b) Flange nut
Flange arrangement when using a straight
cutting wheel (Fig. 10)
a) Clamping flange
b) Flange nut
Seite 12