Luvion ECO FAST DELUXE Manuel D'utilisation page 11

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

INSTRUCTION MANUAL
TO HEAT UP QUICKLY:
1.
Place the bottle basket (8) in the bottle warmer unit and place the bottle or jar (without lid)
in the middle of the bottle basket (8). Depending on the size of the bottle, you could use the
bottle ring (9) to help the small neck bottles t.
2.
Fill the container of the bottle warmer with the below reference water content depending
on the amount of milk or food in the bottle.
3.
Insert the plug into a 230Volts wall socket and turn on the bottle warmer (3).
4.
Press the mode settings button (4) and select the quick heating mode
ashes a few times before the heating element of the bottle warmer starts to work.
5.
The default heating up time is set to 3 minutes. Depending on the amount of milk or food,
the timer can be adjusted by pressing on the buttons (5 and 6). The heat up function will
start working after a few seconds.
The desired temperature of the milk/food is determined by the amount of water in the bott-
le warmer. For low temperature, it is recommended to use more water.
Note: the following chart can only be used as reference and is based on heating the milk/
food of 4°C to a temperature of 37°C. Depending on the initial temperature of the content
of the milk/food, the room temperature, shape/size, material of the bottle or jar, as well as
other conditioning factors, could cause the temperature range to vary. In this case, you may
have to increase/decrease the warm-up time by pressing the buttons (5 & 6).
Note: For the glass jars, the heating time should be at least 30 seconds shorter than the
heating time of plastic bottles.
AMOUNT OF MILK IN PLASTIC
BOTTLE
90ml
120ml
150ml
180ml
210ml
240ml
270ml
330ml
6.
The display (2) starts to count down and when it reaches the 0:00, the bottle warmer will
turn o automatically and 2 cycles of 2 beeps are emitted.
7.
Remove the bottle/jar from the bottle warmer quickly when timer goes o and shake the
milk or stir the food to ensure the heating is spread evenly.
8.
Always check the temperature of your food or milk before serving with the inside of your
LUVION
Premium Baby products
AMOUNT OF WATER ML TO BE PUT
IN THE BOTTLE WARMER
35ml
35ml
40ml
40ml
40ml
40ml
50ml
50ml
11
. The symbol
WORKING TIME
3 minutes
4 minutes
4 minutes
4 minutes
4 minutes
4 minutes
5 minutes
6 minutes
EN

Publicité

Table des Matières
loading

Table des Matières