Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3.3 Daily use
WARNING:
Danger of burning!
The appliance must never be used with the
lid open or missing. Otherwise, there is dan-
ger of burning by spattering liquids.
1.
3
1. Fill the appliance as described under
ZChapter 3.1, "Filling"
2. Push the "ON/OFF" (Fig. 3/1.), switch to
switch on the appliance.
The red indicator-light shows that the ap-
pliance is heating. The indicator shows the
set temperature of "30".
4
3. Now set the desired temperature by turn-
ing the control knob (Fig. 4/2.)
-
By turning clockwise you increase the
temperature in 5°C steps.
-
By turning counter-clockwise you de-
crease the temperature in 5°C steps.
The lowest temperature you can set is
30 °C.
The appliance will now heat the water to the
desired temperature and then switch off auto-
matically. The red indicator-light then goes
off.
ATTENTION:
Do not hold down the buttons of the control
panel. This might damage the electronic
system
2.
NOTE:
The heating is cut off if you remove the
appliance from its base. The set-tempera-
ture indicator will then show "EE". When
you set the appliance back onto the base,
the set temperature is shown again and
heating resumes.
3.4 Automatic switch-off
The appliance has an automatic switch-off
that prevents overheating (within 30 seconds)
to avoid damage to the appliance.
The heating automatically switches off
-
when the set temperature has been
reached.
-
the appliance has been filled with too little
or no water or food,
-
the appliance is removed from the base
during heating.
ATTENTION:
Wait until the heating-plate has cooled off
completely. Only then may the appliance be
filled with water or food again.
Cooking
19
Publicité
Table des Matières
