Connections; Brightness Control; Setting; Autonomous - Gorgy Timing LEDI 2S NTP Mode D'emploi

All necessary connections are made at the back of the case
► Connect the unit
to power supply 230vAC 50-60HZ
► ntp synchronisation input
the brightness is adjusted by pressing on the "+" and "-" button.
the button can be reached through the holes in the front of the unit, using a small screwdriver

4.1. aUTONOMOUS

the time is set by using the "+","-" and "proG" buttons on the front of the unit.
Each time the "PROG" button is used, a different part of the display begins to flash. This is
then modified by using the "+" and "-" buttons.
The setting cycle is as follows:
► Hour, minute, second display: adjustment of hours
► Hour, minute, second display: adjustment of minutes
► Hour, minute, second display: synchronisation
► Hour, minute, second display: time base

4.2. NTP RECEIVER

The display prompts the date of the NTP server on which the LEDI 2/S NTP is synchronized.
20

2. CONNECTIONS

► ntp - poE
3. bRIGHTNESS
MDE-LEDI-2S-NTP-1108V1.0
CONTROL

4. SETTING