PROMAT 4000877173 Mode D'emploi Original page 10

Charging the Battery
Use the included USB charging cable to connect the charging socket (6) of the
lamp to a suitable USB port or use the included power mains adaptor to connect it
to a suitable wall socket..
During charging the charging control light (2) on the front of the lamp lights up red,
when the charge is complete it lights up green.
After charging, disconnect the lamp from the charging cable.
Operation
 Above the light panel (1) is the ON/OFF button (3) and the sensor button (4)..
Press the ON/OFF button to turn on the lighting panel at half power (150 lm).
Press the ON/OFF button again to turn on the lighting panel at full power
(300 lm). Press the ON/OFF button once more to turn off the lamp altogether.
 Press the sensor button (4) to turn on the motion sensor on the lamp. The
sensor control LED (5) turns on and the sensors (7) are activated. Move your
hand swiftly past the front of the lamp at a distance of no more than 10 cm to
turn the lamp on at full power. Move your hand past the front of the lamp again
to turn the lamp off again.
Maintenance and Storing
Do not use aggressive chemicals, solvents or abrasives to clean the lamp. Do not
allow liquids of any kind to enter the lamp or immerse the lamp in liquids of any
kind.
Store the lamp in a place away from direct sunlight, dust, humidity, extreme
temperatures and vibrations and out of the reach of children.
6
Operation