Cleaning And Maintenance; Technical Specifications - Perel Tools PR090012 Notice D'emploi

f. Setting the cutting depth (fig. F)
• Set the depth stop (10).
• Slacken the clamp lever (11).
• Push the device down to the depth stop.
• Fasten the clamp lever.
g. Quick selecting the cutting depth (fig. F)
Quick-select between pre-set cutting depths by means of the revolver depth stop.
• Lift the revolver depth stop from its current fixing point and turn the desired cutting depth position to the position
below the depth stop.
• Make sure the revolver depth stop is secured in the fixing point.
• Follow the instructions above to set the cutting depth.
h. Switching ON/OFF (fig. A)
• switching on: press and hold the operating switch
• Adjust the cutting speeds by means of the dial (13)
• Switching off: release the operating switch

6. Cleaning and Maintenance

CAUTION: Disconnect from mains before starting maintenance operation.
1. All screws or parts of the device have to be tightly connected and must not be corroded.
2. There must not be any deformations on the housing and its accessories.
3. Moving mechanic parts must not show any traces of wear and tear and must be able to rotate unimpeded.
4. The electric power supply cables must be free of damage. Have a qualified technician service the device.
5. Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
6. After operation, clean out the ventilation slots with compressed air (3 bar max.) to prevent the buildup of dust.

7. Technical Specifications

Power supply
Power consumption
Speed
Cutting depth
Spindle diameter
Vibration level
Sound pressure level
Sound power level
Protection class
Weight
* measured according to EN 50144
Note: The EC Declaration of Conformity is attached.
The information in this manual is subject to change without prior notice.
PR090012
max. 230V~ / 50Hz
900W
9000-28000rpm
52mm
6/8mm
5.5m/s²*
88dB (A)*
102dB (A)*
II /
3kg
6 PEREL