Aspen Pumps Xtra AX3007/1 Manuel D'installation Et D'utilisation page 12

Install the Window Slider Kit
1. Cut the foam seal (adhesive type) to the proper length
and attach it to the window sash.
Screw A
2. Attach the window slider kit to the window sash. Adjust the length of the Window
Slider Kit: Loosen the screw A to adjust the length of the Window Slider Kit, then
tighten the screw when the length is suitable.
Note: the length of the Window Slider Kit is 67.5cm to 120cm.
3. Carefully lower the window. Secure the vent panel in place with 4 type B screws,
plus one screw for each extension.
12
Horizontal
Foam Seal A
window sash
Screw B
Vertical
window
slider
kit