Teka TKX1 600T Mode D'emploi page 84

FAILURE FAILURE
CODE INDICATOR
The start/pause
Err 05 light and program
end light blink.
The program
ready light and
Err 06
program end light
blink.
The program
start/pause light,
ready light and
Err 07
program end light
stays on
permanently.
The start/pause
light,program
Err 08 ready light and
program end light
blink.
The program
ready light and
Err 09 program end light
stays on
permanently.
PROBABLE
FAILURE
The heater of your
machine or the
heat sensor has
failed.
The motor has
failed.
Configuration
error.
Fault error
The network
voltage is too high
or too low.
82
THE PROCESS
TO BE DONE
Shut down your
machine and
unplug. Turn off
your tap and apply
to the nearest
authorized service.
Shut down your
machine and
unplug. Turn off
the tap and apply
to the nearest
authorized service.
Shut down your
machine and
unplug. Turn off
the tap and apply
to the nearest
authorized service.
Shut down your
machine and
unplug. Turn off
the tap and apply
to the nearest
authorized service.
If the network
voltage is lower
than 150V or
higher than 260V,
your machine will
automatically stop.
When the network
voltage is
recovered, your
machine will
continue its
operation.