Section 2:Installation; Removal Of Transportation Screws; Adjustment Of Feet - Teka TKX1 600T Mode D'emploi

If you will not use your machine for a long time, unplug your machine,
close the water supply and leave the door open in order to keep the
inside of the machine dry and for prevention from unpleasant odour.
As a result of the quality control procedures, a certain amount of
water may remain in your machine. This is not harmful for your
machine.
SECTION 2: INSTALLATION
You must pay attention to the following issues before using your washing
machine.

REMOVAL OF TRANSPORTATION SCREWS

Transportation screws, which are located at the back side of the
machine, must be removed before running the machine.
Loosen the screws by rotating counterclockwise by a suitable wrench.
(DIAGRAM-1)
Remove the screws by pulling them.(DIAGRAM-2)
To the holes where the transport screws have been removed, insert
the plastic transport screw taps found in the accessories bag.
(DIAGRAM-3)
The transportation screws, that have been removed from the machine
should be kept in hand for any other transportation necessities.
DIAGRAM-1

ADJUSTMENT OF FEET

Do not install your machine on rugs or similar surfaces.
For your machine to work silently and without any vibration, it should
be settled on a flat, non-slippery and tough ground.
DIAGRAM-2
59
DIAGRAM-3