Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
Changing work mode (WAVE TYPE)
You can change to whichever work mode you want for your session by
pressing SELECT.
Choosing between continuous
or pulsed
mode.
Selecting the desired handset (HANDSET)
You can select whichever handset you want for your session by pressing
SELECT.
Choose between the left handset or the right handset. Each of the
handsets can be plugged into either of the two connections.
Finally, take hold of the selected handset to begin your session. Apply
the ultrasound gel to the area of the face that you wish to work and move
the handset over it as indicated in the "Application modes" section.
* Hold down the control button located on the left of the handset
during the entire session.
Control button
You will see the time countdown in steps of 1 minute. The seconds
are shown by the red dot that fl ashes beside the counter.
You can pause/stop the session by releasing the control button on the
handset. The counter will remain paused until you press the button
again.
When the time counter reaches 00 the unit will stop and emit a beep
to tell you that the selected session has fi nished.
11
Publicité
Chapitres
Table des Matières
