Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
Ensure that the water is at the maximum level when you perform this
process. Discharge the hot water before every boiling and wash inside
your appliance with cold water.
• Fill in your water heater water always between the levels min (0.5 lt) or
max (1. 7 lt).
If you attempt
boiling the water
under the minimum
level, it will cause
your appliance to
be shut off earlier
and if you attempt
the water above
the maximum level,
it will cause water
to overflow.
• Open the teapot lid and remove the tea filter and add sufficient amount
of tea in the filter and add some cold water and then replace it on the
teapot.
• Steep the tea with the boiled water and replace the steel teapot. If
necessary, add water to your water heater. If you add water, take the
boiling switch again to the open position.
Boiling Mode:
• Turn on by moving boiling switch to position
( I ). Blue power light will be on and water in the
tea maker will start heating.
• When water is boiled, boiling switch will
automatically switch off and the appliance vice
will shut off.
Keep-Warm Mode:
• Turn on by moving boiling switch to position
( I ) and keep-warm switch to position (
).
Boiling switch will turn blue light on and keep-
warm switch will keep red light on and water will
start heating.
• When water boils, boiling switch will
automatically switch off and keep-warm mode
will be active.
• Turn off the appliance by moving keep-warm switch to position (0) to
ARZUM
7
Publicité
Table des Matières
