Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
MSA Latchways
User Instructions
The Latchways Leading Edge SRL, in accordance with ANSI Z359.14-2014, OSHA 29
CFR 1910.66, OSHA 29 CFR 1926.502 and IRAM 3605: 2005 standards, is intended
to be used as a connecting element within a personal fall arrest system. It should be
typically used vertically in situations where User mobility is required and fall protection
is needed. It may also be used horizontally, as indicated in these instructions.
Latchways Leading Edge SRL has been tested for horizontal use and a drop over an
Edge
has been successfully tested.
1
Date of first use: (page 2) The date the unit is removed from the packaging.
1 General information
Failure to follow these instructions may cause serious injury or death. Instructions shall
be retained and provided to all Users of Latchways Leading Edge SRLs in the language
of the destination country, even when resold.
A declaration of conformity may be downloaded at
www.msasafety.com
Warranty details
Full terms and conditions can be found at www.msasafety.com.
2 Product Markings
Model number
1
Serial number
2
Date of manufacture MM/YY
3
Length
4
Load-indicator
5
Notified body number
6
3 Intended use and product limitations
The Latchways Leading Edge SRL is designed for applications where falls may occur
over edges, such as roofing, leading edge construction etc.
The Latchways Leading Edge SRL shall only be used within it's limitations and for the
purpose for which it is intended. All instructions shall be followed to ensure the safety
of the User. Authorised repairs are to be conducted by a Technician.
1. Latchways Leading Edge SRLs are for a single user only, only one person can be
connected at any time.
*Date of first use shall be administratively provable. Where the date of first use is unknown, then the next previous
administratively provable date shall be used, e.g. date of purchase or date of manufacture.
1. Edge: A steel edge with a radius of r = 0.005 inches (0.13 mm) and without burrs was used for the test. This is
similar in nature to rolled steel profiles, wooden beams or clad, rounded roof parapets. Protection to the lifeline shall
be provided by the User when working near extremely sharp edges such as sheared, cold rolled or flames cut steel.
Leading Edge SRL
®
7
8
9
10
11
12
3
Applicable standard
Do not use
Product limitations
Product warning
Pre-use checks
Date of next examination
EN
EN
Publicité
Table des Matières
