Pro Work OFJ 850E Mode D'emploi page 7

Anleitung OFJ 850 E SPK 1
1. Description of the machine
(Fig. 1 and 2)
1 Handle
2 Scale
3 Depth stop
4 Motor housing
5 Mains cable
6 ON/OFF switch
7 Speed selector
8 Thumscrew
9 Guide bush
10 Trammel point
11 Routing base
12 Spindle catch
13 Parallel stop
14 Spanner size
15 Clamping handle
16 Extractor socket internal
2. Technical data
Voltage: 230 V - 50 Hz
Power consumption:
Idle speed: 11.500 - 28.000 rpm
Stroke/routing depth:
Collet: Ø 8 and Ø 6 mm
For moulding cutters: max. Ø 40 mm
Safety insulated
Weight:
Sound pressure level LWA: 87,9 dB(A)
Sound power level LPA 100,9 dB(A)
Vibration aw:
3. Intended use
The router is ideal for the processing of wood and
plastic, for the removal of knots, for the cutting of
grooves and recesses, and for the copying of curves
and lettering etc.
It is prohibited to use the router to process metal,
stone and similar materials.
The machine is to be used only for its intended pur-
pose.
Any use beyond its intended purpose is a case of
mis-use. Liability for damage or injury resulting from
such a case of mis-use shall rest with the user or
operator and not with the manufacturer.
04.03.2004 7:14 Uhr
4. Important information
Please read the operating instructions carefully and
note their contents. Use these operating instructions
to acquaint yourself with the machine, its proper use
and essential safety precautions. Keep the operating
instructions together with the router.
Safety information
Make sure the machine is switched off before
inserting the plug in the socket-outlet.
Clamp the workpiece securely to prevent it from
slipping.
Always run the cable away from the back of the
machine.
Always remove the plug from the socket-outlet
before doing any work on the machine
Check that the cutter is fitted securely before
starting up the machine.
Always make sure of your footing while using the
machine.
The direction of routing must always be opposite
to the cutter's direction of rotation.
Do not feed the cutter into the workpiece until it is
850 W
running.
Always guide the router with both hands.
Never exceed the maximum speed specified for
40 mm
the cutter.
Make allowance for the machine's reaction torque,
particularly if the cutter jams.
When you are finished, allow the machine to glide
back into starting position.
II /
Use only properly ground cutters.
3.3 kg
Mount the cutter with friction locking.
Depending on the material, deeper cuts should be
performed in several passes.
The level of noise at the workplace may exceed 85
26,8 m/s
2
dB(A). In this case you will need to introduce noise
protection measures for the user. The noise pro
duced by this electric tool was measured in accor
dance with ISO 3744, NFS 31-031 (84/637/EEC).
Vibration emission was measured in accordance
with ISO 8662-8.
5. Prior to operation
Before starting the router, make sure that all its
guards and safety devices are properly fitted.
Before connecting up the router, make sure that
your power supply complies with the data on the
machine's rating plate.
Seite 7
GB
7