Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
FAN STRUCTURE
INSTALLATION
1.
Slide the two bars into each other, creating the crossed pedestal (16).
2.
Use the 4 screws to fix the lower tube (15) onto the crossed pedestal (16).
3.
Loosen the connector between the tubes (14) from the lower tube.
4.
Place the cover (17) over the lower tube (15) and let it fall over the crossed pedestal (16).
5.
Place the connector between the tubes (14) back onto the lower tube (15), but don't tighten the
connector yet.
6.
Slide the upper tube (13) out of the lower tube (15) to extend it.
7.
Re-tighten the connector between the tubes (14) on the lower tube.
8.
Place the housing of the motor (8) and switches (11) onto the upper tube and tighten it to the upper tube (13)
using the fixing screw (12).
9.
Loosen the locknut (3) and mounting nut (5) of the motor shaft (7).
10.
Slide the protective rear cover (6) with the handle upwards over the motor shaft (7).
11.
Tighten Mounting nut (5) anti-clockwise against the fan blades (6).
12.
Schuif de ventilatorbladen (4) over de motoras (7).
13.
Tighten the locknut (3) anti-clockwise against the fan blades (4).
14.
Turn the clips of the protective front cover (2) outwards and hang the protective cover over the edge of the
protective rear cover. Make sure that the opening at the bottom of the protective front cover is aligned with
the opening at the bottom of the protective rear cover.
15.
Insert the screw (1) through both openings at the bottom of the protective covers and fix the covers together
using the nut.
16.
Finally, close the clips around both protective covers.
1. Fixing screw for the fan covers
2. Protective front cover
3. Locknut
4. Fan blades
5. Mounting nut
6. Protective rear cover
7. Motor shaft
8. Motor housing
9. Oscillation button
10. Speed switches
11. Housing of the switches
12. Fixing screw
13. Upper tube
14. Connection between the
tubes
15. Lower tube
16. Crossed pedestal
17. Cover
17
8
Publicité
Table des Matières
