Installation Instructions - Intenso 3,5 MEMORYCENTER Notice D'utilisation

Installation Instructions

System Requirements:
This hard drive is compatible with the operating systems MS Windows
XP / Vista / Windows 7 and Mac OS 10.x.
Please note:
For the USB 3.0 operation an USB 3.0 interface card is needed. The hard
disk is downwardly compatible with the previous USB standards.
Your PC's hardware configuration as well as the operating system
employed can influence the compatibility of the hard drive.
Hard Drive Connection:
Connect the power supply provided to the external hard drive. Insert the
other ending of the power supply into the plug. To switch on push the
on-off switch ( I / 0 ) on the frontal side of the box.
To connect the external hard drive to your computer, please use only the
USB cable provided. Connect the USB 3.0 plug type B with the Intenso
hard drive and the plug of the USB 3.0 type A with your computer.
The computer automatically detects the "New Device" and installs the
driver. Please wait until driver installation is completed. Your computer
now shows an additional drive named "Intenso".
As soon as the hard drive is connected to your computer, the LED
flashes. The LED flashes, when writing or reading procedure is carried
out.
Trademark: Windows XP / Vista / Windows 7 are registered trademarks of the
Microsoft Corporation. Macintosh and MAC are registered trademarks of Apple
Computer. All trademarks and names of third parties are property of the respective
user.
Page 4 of 5 GB