Smartpond 52256 Mode D'emploi page 9

Step 8. If you would
8
like to run the cord
through the bottom of
the container, widen the
existing hole or create a
hole approximately 1-1/4-
in in diameter.
NOTE: Appropriate safety
equipment should be
9 10
used while drilling.
Step 9. Glue the
container stands evenly
across the bottom
surface near the outside.
Step 10. Place the pump
11 12
inside the container and
run the cord through the
hole. Push the rubber
stopper on the cord into
the hole until it seals well.
Step 11. If needed,
attach the extensions to
the bottom of the filter
box.
Step 12. If needed, use the cord holder to tie a loop in the cord.
This will help the pump stay in place.
PLEASE CALL CUSTOMER CARE BEFORE RETURNING ITEM TO LOWE'S: 1-888-755-4497 6