Taking Out Of Operation - HellermannTyton SpotClip-III Manuel D'utilisation

1 Take the flattened product out of its package.
2 Click in the folding assembly legs
(Figure ) using the folding mechanism
A
3 Clean the area surrounding the ceiling cut-out.
4 Insert the product into the ceiling cut-out (Figure
three support wings
cut-out.
5 Press the three retaining spikes
to prevent subsequent slippage.
6 Check the product for firm seating.
7 Install the light (Figure
8 Connect the external power supply (Figure
9 Fasten the supply line for the light with the cable retainers
(Figure ) on the heat protection top.
G
; The SpotClip-III is installed.
6 Maintenance
The product requires no maintenance.

7 Taking out of operation

When used for its intended purpose, the product will perform
continuously without issues.
8 Disposal
At the end of use, the purchaser or the user must dispose of the
product properly. This product has been manufactured in
compliance with the current environmental standards.
f Observe the national regulations for the disposal of recyclable
fractions.
f Take the product to a local collection point or recycling centre.
f If necessary, contact your local enviromental office.
Operating Instructions • SpotClip-III • 07-2015
in the heat protection top
3
(Figure ) are resting above the ceiling
4 E
(Figure
5
) according to the operating instructions.
F
Maintenance
(Figure ).
7 C
) until the
D
) into the plasterboard
E
) to the light.
G
6
2
7