VONROC TS501AC Traduction De La Notice Originale page 15

Crosswise sawing with a vertical mitre
This method is practically the same, except that the
saw blade is placed in the angle required.
Only place the cross-cut fence on the
righthand side of the saw blade. Never saw
too small pieces of wood. Never use your
hands to carry out difficult operations.
Crosswise sawing with a horizontal mitre
With this method the cross-cut fence must be
secured at the angle required. Keep the workpiece
pressed firmly against the cross-cut fence and the
bench before you start cutting off.
Transporting the table saw
Before transporting the bench saw, the following
steps must be carried out:
• Pull the mains plug
• Turn the hand-wheel (9) (Fig. A2) in anticlockwise
direction, lower the blade as much as possible
• Remove all accessories that cannot be mounted
firmly to the power tool
If possible, place unused saw blades in an enclo-
sed container for transport
• Wind the mains cable and bind it
• For lifting or transport, carry the main table (1)
(Fig.A1)
The bench saw should always be carried by
two persons in order to avoid back injuries.
5. MAINTENANCE
Before cleaning and maintenance, always
switch off the machine and remove the
mains plug from the mains.
Clean the machine casings regularly with a soft
cloth, preferably after each use. Make sure that the
ventilation openings are free of dust and dirt. Re-
move very persistent dirt using a soft cloth moiste-
ned with soapsuds. Do not use any solvents such
as gasoline, alcohol, ammonia, etc. Chemicals such
as these will damage the synthetic components.
WWW.VONROC.COM
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/EU
for Waste Electrical and Electronic Equipment and its
implementation into national right, power tools that
are no longer usable must be collected separately
and disposed of in an environmentally friendly way.
WARRANTY
VONROC products are developed to the highest qua-
lity standards and are guaranteed free of defects
in both materials and workmanship for the period
lawfully stipulated starting from the date of original
purchase. Should the product develop any failure
during this period due to defective material and/or
workmanship then contact your VONROC directly.
The following circumstances are excluded from this
guarantee:
• Repairs and or alterations have been made
or attempted to the machine by unauthorized
service centers;
• Normal wear and tear;
• The tool has been abused, misused or im-
properly maintained;
• Non-original spare parts have been used.
This constitutes the sole warranty made by compa-
ny either expressed or implied. There are no other
warranties expressed or implied which extend
beyond the face hereof, herein, including the im-
plied warranties of merchantability and fitness for
a particular purpose. In no event shall VONROC be
liable for any incidental or consequential damages.
The dealers remedies shall be limited to repair or
replacement of nonconforming units or parts.
The product and the user manual are subject to
change. Specifications can be changed without
further notice.
EN
15