Rear Panel - Boost MELROSE Mode D'emploi

D E S C R I P T I O N :
D E S C R I P T I O N :
1. MIC LEVEL CONTROL
Used to adjust the level of the micro signal
2. MIC HIGH TONE CONTROL
This rotary level adjust the HIGH frequencies of the MIC signal (± 10 dB).
Note : Too much adjustments can distort the sound.
3. MIC LOW TONE CONTROL
This rotary level adjust the LOW frequencies of the MIC signal (± 10 dB).
Note : Too much adjustments can distort the sound.
4. CHANNEL GAIN CONTROL
Used to adjust the level of the input signal. Useful to harmonize the level of all the inputs.
5. CHANNEL HIGH TONE CONTROL
These rotaries level adjusts the HIGH frequencies of the channel 1 and channel 2 signals (-26/+12dB).
Note : Too much adjustments can distort the sound.
6. CHANNEL LOW TONE CONTROL
These rotaries level adjusts the LOW frequencies of the channel 1 and channel 2 signals (-26/+12dB).
Note : trop de corrections peuvent déformer le son
7. CHANNEL INPUT SELECTOR
This commutator gives you the choice between 2 inputs, either a phono input ( turntable ) or a line input ( CD player, DVD player, ... ).
8. CHANNEL LEVEL CONTROL
The channel level sliders controls can be used to adjust the individual input to obtain the desired volume of each channel.
9. MIC SOCKET
The microphone input accepts a ¼'' jack connector
10. POWER INDICATOR
This led lights on when you switch your mixer on and lights off when you switch your mixer off.
11. MASTER LEVEL CONROL
Used for adjusting the level of the master output signal.
12. PHONE LEVEL CONTROL
Used for adjusting the level of the stereo headphone.
13. CUE MIX
This fader is used to set up mixer and special effects in the left position, "cue" are heard to the headphones. In the full right position "master"
are heard to the headphones.
14. CROSSFADER
This horizontal slider provides clean seagues between channel 1 and channel 2 and vice-versa. At center position, both channels will be
heard.
15. VUMETER
Those LEDs indicate the left and the right levels of the Master output
Note : When the red leds lights on, that mean the level is too high. Reduce it in using the master control or channel level controls.
16. PHONE SOCKET
Stereo input jack for headphone (diameter 6.35mm). The output is 100mv/8 ohms)..

REAR PANEL :

17. POWER SWITCH
Press this switch to turn the power ON, press again to turn the power OFF. When operating this switch, make sure that all controls are set at
minimum position.
18. POWER SUPPLY SOCKET
input socket for 12V / 800mA power supply adapter ( provided with the mixer )
19. REC OUTPUT
Stereo output for connection of an outboard tape deck. This output is post EQ but is not affected by the master output.
20. MASTER OUTPUT
The stereo outputs are low impedance, unbalanced RCA jacks. The output level is controlled by the MASTER fader. Connect this to power
amp.
21. PHONO INPUT
You can plug on this connector a Phono level device ( turntable)
22. LINE INPUT
Those RCA can be connected to the CD/LINE level devices like cd player, minidisc player,....
23. GROUND SOCKET
The GND is a terminal for grounding turntables to eliminate hum. Connect it to your turntable
E N G L I S H
E N G L I S H