Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CHEF PRO
auger and by the front door);
EN
• open the slide located in the upper part of the container,
letting it run towards the outside (fig. C);
• fill the container with food (flakes or granules), trying
IT
not to pack in too much;
Warning! If you turn the auger with the slide open, the
FR
feeder will jam. Remove and replace the slide correctly,
starting it up again.
REGULATING THE AMOUNT OF
D
FOOD TO BE SUPPLIED
There are 4 different hatches that can be applied to the
container outlet, on the basis of the type of food being used:
NL
• 2 hatches suitable for granular food (fig. D) we suggest
using granules not bigger than 1 mm.
• 2 hatches to partially close the outlet hole (1/3 and 2/3).
ES
Particularly suitable for flaked food (fig. E).
After having chosen the hatch and loaded the food, we
recommend testing it to make sure that it works properly
PT
(MANUAL button), allowing you to assess whether the
selected quantity of food is correct (the amount of food
that should be eaten by the fish in 3 minutes).
SK
Warning! To ensure the right working of the product all
the hatches must be correctly inserted in their compart-
CS
ment, till you hear a click.
MAINTENANCE:
CLEANING THE CONTAINER
HU
In order to allow for thorough cleaning, the food container
can be easily extracted from the motor body:
• take it to the cleaning area;
SV
• press the two side buttons in correspondence to the
control panel at the same time and slide out the whole
container (fig. F);
DA
• take off the front hatch of the container by pulling it up
(fig. G);
• slide off the container cover by pressing the two side
RU
buttons;
• clean the container carefully (do not use detergents or
PL
chemical substances!);
• put the container back together, assembling it in the
following order: container body › auger › container
6
cover › slide › front hatch, making sure that the auger is
positioned enabling the closing of the container outlet
hole;
• restore the entire container to the motor body.
BATTERY REPLACEMENT
We recommend always replacing the batteries:
• before a long period of absence;
• when the relative red LED intermittently flashes slowly;
• after the device has been out of use for a long period of
time.
Replace the batteries as follows:
• open the relative hatch (fig. H);
• remove the flat batteries and insert the new ones,
• make sure that you respect the polarities (see the raised
indications on the plastic);
• close the hatch.
Warning! Failing to respect the polarity could definitively
prejudice the working order of the electronic board!
SPARE PARTS AND ACCESSORIES
CHEF PRO feeder spare parts are available from the shop
you purchased the product from. Numerous Ferplast
accessories are also available. Our accessory range is con-
stantly updated and caters for a wide range of fish tank
requirements. Only use original Ferplast spare parts when
replacing any components in order to ensure that your
product maintains its working order and safety standards.
The use of non-original spare parts renders the guarantee
null and void.
GUARANTEE
This product, all its parts and accessories are covered by
warranty within the limits provided for in this paragraph
and the legal regulations currently in force. The guarantee
only covers manufacturing defects and includes the repair
or replacement of the product free of charge. The guar-
antee does not cover damage and/or defects caused by
carelessness, wear, unsuitable usage not complying with
the instructions and warnings in this manual, accidents,
tampering, incorrect use, bad repair work or purchases not
accompanied by a fiscal receipt.
Publicité
Table des Matières
