Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Fasten the spacers to the dryer with the 12 mm screws. Use the help of a second
person to attach the dryer to the wall bracket.
Hose connection
Warning : 2 people may be required to install the hose. It is recom-
mended to wear gloves
Note: Ventilation hose assures exhauting of the aire from the inside of
the tumble dryer.
•
Carefully remove all packing materials including from the foam,
dispose of correctly.
•
Before installation, ensure that the unit is power off and unplug
frome the mains.
1.
According to the order of arrows shown in Fig.5, three part are
combined int exhauts hose assembly.
2.
Put the exhaust hose assembly on the connector base in the
desired (upper, lower, left, and right), as shown in Fig.6.
3.
Turn the exhaust hose must be extended clockwise until it is
clamped firmly, as shown in Fig.7.
•
The air outlet hose must be extended directly to oudoors. Keep
bends to minimum to ensure adequate ventilation.
•
To prevent water accumulation in the hose, make sure the hose is
not folded on the floor.
•
In winter, the room temperature may be cold. The water may
condense inside the hose. Periodical check is requerid to avoid
hose damage by the water.
Warning : Do not connect the hose to the chimney of a stove of a
stove or fireplace.
Spacers
Screws 12mm
Retaining clamp
mounting points
Fit the metal ring on
the exhaust hose
Tighten it with a Phillips screwdriver
Exhaust hose assembly
Insert the exhaust
connector
Connector base
11
Publicité
Chapitres
Table des Matières
