Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3
Installing the AM6162L Indoor amplifier
Method 1
TV SIGNAL DISTRIBUTION
1 Connect your UHF/VHF aerial downlead
(tipically via an aerial wall socket) to the ANT
socket on the amplifier.
2 Connect up the four TVs to the TV socket
on the AM6162L
Method 2
TV/VCR/DTT
1 Connect your UHF aerial downlead to the
aerial input VCR & DTT receiver.
2 Connect an aerial fly-lead from the aerial
output on the DTT receiver to the aerial UHF
input of the AM6162L.
3 Connect up two TVs to the TV socket on
the AM6162L
Method 3
TV/VCR/DTT (digital Terrestrial
Television) DISTRIBUTION
1 Connect your UHF aerial downlead to the
aerial input on the DTT receiver
2 Connect an aerial fly-lead from the aerial
output on your DTT receiver to the aerial
input on your VCR recorder and its output
connect to the AM6162L UHF input
3 Connect an aerial fly-lead from the aerial
output of VHF Modulator to the antenna
input of AM6162L
4 Connect up four TVs to the TV socket on
the AM6162L.
Once connected you can tune each
television to traditional terrestrial channels,
a channel VCR viewing and a channel for
DTT viewing
Some DTT/SAT receivers do not have a RF
output channel. Then use the external
modulator (MV7125, see fig 3)
If you are receiving poor DTT reception then
connect the AM6162L before your DTT
receiver to help boost the signal strenght.
In most cases, poor DTT reception can
only be cured by acquiring a suitable aerial
(see troubleshooting) or waiting until DTT
coverage improves in your area.
UK
Publicité
Table des Matières
