Bluetooth - Ryobi P742 Manuel D'utilisation

for that device or by using the radio's VOL + or VOL –
button.
 Turning the radio off will NOT turn the phone/MP3 player
off.
 The auxiliary cable DOES NOT provide charging function.
 For complete operating instructions for the connected
device, always refer to the manual that was included with
your device.
USING A BLUETOOTH
(NOT INCLUDED) WITH THE RADIO
See Figure 5, page 10.
 Press the MODE button until the BLUETOOTH
is highlighted.
 When the radio is switched to BLUETOOTH
unit will attempt to pair to a BLUETOOTH
and "bt" will flash in the LCD display.
NOTE: The radio will automatically attempt to connect to
the last device it was paired to. If a connection cannot be
established within five seconds, the radio will make itself
available to other BLUETOOTH
 BLUETOOTH enabled devices must be within 30 ft. of
®
the radio and set to search/scan in order to pair with the
radio.
 Select "RYOBI Radio" from your device's list of available

BLUETOOTH

signals to pair the device and the radio.
®
No password or PIN is required for connection.
 When the device has successfully paired with the radio,
"bt" will stop flashing.
NOTE: When a device is paired to the radio, informa-
tion for connecting to the device is saved in the radio's
memory.
OPERATION
ENABLED DEVICE
®
mode
®
mode, the
®
enabled device
®
enabled devices.
®
 When streaming audio from a BLUETOOTH
device, press the SCAN left and right arrow buttons to
go to the previous or next track. Briefly press and release
the PRESET button to cycle between pausing and playing
the audio.
NOTE: These controls may not be supported by the
BLUETOOTH
®
 All BLUETOOTH
normally while paired to the radio.
NOTE: Volume for any device paired to the radio can be
adjusted using the volume control for that device or by
using the radio's VOL + or VOL – button.
 To disconnect the BLUETOOTH
and hold the PRESET button. When the device is discon-
nected, "bt" will begin flashing in the LCD display and the
radio will begin searching for another device.
USING THE USB DEDICATED CHARGING PORT
The USB dedicated charging port provides charging power
of 5 Volts DC at up to 1 Amp for your cell phone, MP3 player,
or other USB devices.
NOTICE:
Attempting to charge devices rated more than 1 Amp,
such as a tablet, could damage the USB dedicated charg-
ing port and/or the device.
 Connect one end of a USB cable (not provided) to your
USB device.
 Connect the other end of the USB cable (not provided) to
the USB dedicated charging port to begin charging the
device.
NOTE: The USB dedicated charging port provides
power only; it does not provide any data communication
capabilities.
7 — English
device and/or application you are using.
enabled device controls can be used
®
enabled device, press
®
enabled
®