ECG FS 91 T Mode D'emploi page 25

Masquer les pouces Voir aussi pour FS 91 T:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 40
DESCRIPTION
A Fan
1.
Display
2.
Front cover with the mechanism for vertical
setting of slats.
3.
Transparent decorative part
4.
Inner slats drum
B C Control panel and remote control
1.
Timer button
2.
On/Speed selection button
3.
Off button
D Display
1.
High fan speed
2.
Medium fan speed
3.
Low fan speed
4.
Timer display
5.
IR receiver
ADVANTAGES OF THE APPLIANCE
Ionization technology for air purifi cation
Timer adjustable for 1, 2, 4 or 8 hours
Horizontal oscillation in 80° range
LED display
INSTALLATION
Attention: The fan may be used only if it is properly and completely assembled, including the base and
the guard grill. If you have any doubt, have the appliance inspected or assembled by a qualifi ed
professional.
Insert the bottom pin of the vertical component in the central opening of the base and secure it with plastic
nut. You have to tighten the nut fi rmly to prevent swaying.
USE
Make sure prior to each use that the fan is in good condition and the power cord is not damaged. The appliance
must not be used when the power cord is damaged.
The function of the fan can be controlled using either the buttons on the control panel or the remote control.
You have to point the remote control at the control panel. Before you use the remote control insert a coin
battery (CR2032 3V). Keep proper polarity of the battery. If the appliance is not used for long periods, remove
the battery from the remote control.
Connect the unit to the power supply with corresponding voltage and frequency (220V ~ 240V, 50Hz).
Button functions:
(The buttons on the remote control have the same function as the buttons on the appliance)
ON/SPEED 2
Start the appliance by pressing ON/SPEED. After turning it on you can use other functions/buttons. You can
use this button to set the air fl ow speed during operation. Press to switch speeds in the following order: low ->
medium -> high -> low -> etc.
TIMER 1
Press TIMER button to enter the timer setting mode.
5.
Back cover with compartment for remote control
6.
Rear grill
7.
Front part of the base
8.
Back part of the base
4.
Oscillation button
5.
Mode selection button
6.
Oscillation
7.
Night mode
8.
Summer mode
9.
Norma mode and ionization (active in all modes)
3 speeds and 3 air fl ow modes
Remote control with a range of 6 m
Easy assembly without need for tools
Removable back grill, easy cleaning
GB
25

Publicité

Table des Matières
loading

Table des Matières