General Operation; Language Setting; Programming Mode - Omni International Bead Ruptor 12 Manuel D'utilisation

1.
2.
3.
4.
5.
1. Program Number
2. Speed
3. Cycle Time
4. Navigation Buttons
5. Parameters Adjustment Buttons

Language Setting

Turn unit off. Press and hold
 
to select.
Choose from French, English, German, Italian, or Spanish.

Programming Mode

 
UP and DOWN - navigate through menu.
 
LEFT and RIGHT - adjust the parameters.
PARAMETER
S
Speed / Energy
T
Time
C
Number of Cycles
D
Dwell/Pause between Runs
- When the settings are entered press up
- Press "Run" to start.
- At the end of the program "DONE" will be displayed Followed by "REMOVE SAMPLES".
- If run is stopped system status will read "PROGRAM PAUSED".
- Pause or Stop a run anytime by pressing the "STOP" button.
- Press "STOP" again to cancel current run.

General Operation

PROG 01
S =4.50
T=0:10
READY

while powering on unit.
OPERATING RANGE
From 0.8 m/s to 6 m/s
From 0:01 to 9:59 in increments of 1
second
1 to 10
0:00 to 9:59

or down
20 o C
C=02
D=0:10
6. Processing Chamber Temperature
7. Number of Cycles
8. Time interval or Dwell between each cycle
9. Run Button
10. Stop Button

to return to the program option.
6.
7.
8.
9.
10.