Care And Maintenance - KREBS LM25 Mode D'emploi

Instructions for use
Before switching on the spray gun, ensure that the container is at least 50% full of material
in order that it creates a vaccum. Do not use without material - this will create unnecessary
noise and vibration.
Spray material
Note: for the perfect functioning of the spray gun, clean spray material is of importance.
Products containing granules or bodies must not be sprayed as they act abrasively, may
restrict the movement of the piston and shorten the sprayer's life, thereby invalidating the
warranty. In case of doubts regarding any impurities, a fi ne-meshed fi ltering of the spray
material is recommended.
Regulating the Spray Jet
Turn the regulating knob completely to the left. (picture 1)
Switch on the spray gun.
Turn the regulating knob to the right until the spraying cone and atomization are correct.
The spray mist should be even, fi ne and without drops.
Readjust the spray jet similarly before each spraying operation.
Due to the high pressure of the spray gun, if spraying very fi ne liquids such as water, ensure
that the nozzle is fi rmly tightened - use a towel if necessary - and reduce the power setting
utilised. The LM45 is not recommended for spraying water as creates too much pressure for
thin viscosity materials.
Always screw down the container fi rmly. (picture 2)
A test should be carried out to determine the most effective distance from the spraying
surface. Start at a fairly large distance. Ensure that you keep at a constant distance and
that your movements are steady. The distance of the nozzle from the item being sprayed
depends on the spray material (approx. 20-35 cm spraying distance depending on the cone
of the jet and the thickness of the liquid).
Note: Spraying material tends to drip off vertical surfaces. Perform an initial spraying from a
slightly greater distance.
Never spray until the container is empty. The suction pipe must always be immersed in
liquid.

Care and Maintenance

Always disconnect the plug from the power socket before carrying out any work on
the spray gun.
Always keep the spray gun clean.
Never immerse the spray gun in cleaning agent!
Clean the spray gun periodically by spraying through a suitable food safe mild detergent.
Rinse it thoroughly thereafter with fresh water. See instructions of the cleaning agent
manufacturer. When the spray gun is not used for a longer time, spray through a light food oil
for conservation. If the spray gun should happen to fail despite the care taken in manufacture
and testing, repair should be carried out by an authorised representative. For all correspon-
dence and spare parts orders, always include the order number.
7