About Ce And Doc; Disposal; Fcc Information - Icom IC-SAT100M Notice De Base

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

■ About CE and DOC

Hereby, Icom Inc. declares
that the versions of IC-
SAT100M which have
the "CE" symbol on the
product, comply with
the essential requirements of the Radio
Equipment Directive, 2014/53/EU, and the
restriction of the use of certain hazardous
substances in electrical and electronic
equipment Directive, 2011/65/EU. The full
text of the EU declaration of conformity is
available at the following internet address:
https://www.icomjapan.com/support/

■ Disposal

The crossed-out wheeled-
bin symbol on your product,
literature, or packaging reminds
you that in the European Union,
all electrical and electronic
products, batteries, and
accumulators (rechargeable batteries)
must be taken to designated collection
locations at the end of their working life.
Do not dispose of these products as
unsorted municipal waste. Dispose of them
according to the laws in your area.
About E-marking: Detailed installation notes for
Icom mobile transceivers to be fitted into vehicles
are available. Please contact your Icom dealer or
distributor.

■ FCC information

This equipment has been tested and found
to comply with the limits for a Class B
digital device, pursuant to part 15 of the
FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and
can radiate radio frequency energy and,
if not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct the
interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/
TV technician for help.
CAUTION: Changes or modifications to
this transceiver, not expressly approved
by Icom Inc., could void your authority
to operate this transceiver under FCC
regulations.
This device complies with part 15 of the
FCC Rules. Operation is subject to the
condition that this device does not cause
harmful interference.
1
1
2
2
3
3
4

Publicité

Table des Matières
loading

Table des Matières