Jacques Seban CSJS Mode D'emploi page 18

3. Use
3.1. Before connecting the equipment to the power supply
 Install the equipment on a stable, flat surface, in a ventilated area.
 Check that the buttons are in the "OFF" position (Fig. 3)
 Connect the power lead (Fig. 2 - Ref. 6) to a mains power socket.
 Install the water tray (Fig. 2 - Ref. 7) horizontally and correctly, holding it with
both hands.
3.2. Operation
 Open the door of the unit and take the towel tray out (Fig. 2 - Ref. 8).
 Put damp towels on the tray, then put the tray back in the unit.
ATTENTION: Do not put too many towels in at once to avoid all contact with the
heating device.
 Close the door of the unit.
 Set the HEAT button (Fig. 3) to the "ON" position
 The indicator light comes on and the unit starts to operate.
 Set the HEAT button (Fig. 3) to the "OFF" position when you have finished using
the unit.
 Take the towels out of the unit. The towels can be very hot; always use tongs to
take them out of the unit.
ATTENTION: All the components of the unit heat up during use; avoid all contact
when removing towels.
We recommend a minimum of 30 minutes and a maximum of 60 minutes depending
on the desired temperature and the thickness of the towels.
Take care to empty the water tray before it fills up completely.
3.3. Ultraviolet disinfection system
The unit is equipped with an ultraviolet disinfection system.
 Set the UV button (Fig. 3) to the "ON" position
 Set the UV button (Fig. 3) to the "OFF" position when you have finished using the
unit.
PROFESSIONAL TOWEL WARMER
18
EN