How To Use - Panasonic NC-ZK1 Mode D'emploi

How to Use

Open the lid and fill with
1
water.
Opening the lid
• Press the lid
release button.
With another
container
Maximum water level
Minimum water level
Adjusting the length of the mains lead
* Wind the mains
lead on the
bottom of the
power base
to adjust the
length.
20
Close the lid, put the
2
kettle on the power base
and insert the mains plug.
Closing the lid
• Close the
lid firmly as
illustrated until
you hear a
click.
Max
1.4
1.0
0.6
* Pass the mains lead out through the
cut out section.
( )
Do not put the power base on the
mains lead.
Turn on the power switch.
3
(Press " ")
Max
1.4
Start boiling the
1.0
water.
(
0.6 Power indicator
lights up.
During use, the power
indicator lights up.
When the water has boiled, the power
switch turns off automatically.
• The kettle takes around 3 minutes to boil.
(
Water temperature 23°C, room
temperature 23°C, water to max level
• To stop boiling before the
water has boiled, turn off
the power switch.
Note
• Immediately after the water has boiled,
do not force the kettle to continue heating
the water by keep pressing the power
switch. (It may cause malfunction.)
Empty-use prevention function
When the power switch is on without water, an empty-use prevention function works to
automatically turn off the power in order to prevent accidents and malfunction due to
overheating.
 Allow the body to cool sufficiently.
 Remove the body from the power base and fill the water.
 Place it on the power base and turn on the power switch again.
* If you boil the kettle without water, it may smell strange.
Remove from the power
4
base and pour.
Max
1.4
1.0
0.6
)
)
 After use, pour out any remaining
water.
* Keep the lid closed when pouring
away the water.
21