Basic Operation / Charging The Battery - Impecca HSB100 Manuel De L'utilisateur

BASIC OPERATION
Follow these tips and safety instructions to preserve the operational lifespan of your Bluetooth Wireless
Stereo Headset:
 Do not use this player in extreme temperatures. Keep away from extreme hot, cold, dry, or damp
areas. Also keep away from water, fire, and radiation.
 It is recommended that you allow the battery to fully charge before using the device for the first time
(approximately 2 to 3 hours. Do not recharge unattended for longer than 5 hours.
 The effective range for this wireless device is 10 Meters. Performance may be affected by distance and
interference from other devices or conditions within the operating environment.
 Barriers and other wireless devices may affect the performance of headset.

Check the laws and regulations on the use of mobile phones and hands-free equipment in areas you
intend to use this product.
 Permanent hearing damage or hearing loss may occur if earphones are used at a high volume. Hearing
experts advise against continuously listening to music at a high volume. If you hear a "hissing" noise in
your ears, or if you experience discomfort, lower the volume, or temporarily discontinue use of this
product until discomfort subsides.
 Do not disassemble your Bluetooth Wireless Stereo Headset.
 Do not allow young children to use your player unsupervised.
 Observe all signs and instructions that require an electrical device or radio product to be switched off
in designated areas, such as petrol/refueling stations, hospitals, blasting areas, potentially explosive
atmospheres or aircraft.
 Do not use or connect adaptors and/or chargers to this product that are not approved of or specified
by IMPECCA™.
CHARGING THE BATTERY
The Red LED will continually flash when battery power is low. When the battery is completely drained, no
indicator lights will function. Before using, allow the battery to charge for at least 2 to 3 hours.
1. Connect the mini USB cable to the USB Jack on your headset (as shown).
2. Connect the larger end of the USB cable to a USB port on your PC or
Laptop.
3. The Red LED will stop flashing and will remain solid red.
4. When charging has finished, the Red LED will turn off.
- 4 -