Switching Commands; Pulse Operation; Manual Operation - Elbro SMS Switch Butler SMSB10 BD Mode D'emploi

SMSB10 BD V1.01
3

Switching Commands

The SMSB10 BD is very simply operated via a call. The call is automatically ended following
one or two rings—there is thus no charge involved.
If you have activated the SMS acknowledgement (2
then the SMSB10 BD sends an SMS following each switching sequence. This
acknowledgement can only be received with a mobile or SMS-capable conventional
telephone.
3.1 Representation
Communication between your telephone and the SMSB10 BD is as follows:
R SMS Text
⇒
Call
⇐
Sample
3.2 Bistable Operation
R SMS Text
⇒
Call
⇐
GSM Remote Control:
OFF
GSM Remote Control:
ON

3.3 Pulse Operation

R SMS Text
⇒
Call
⇐
GSM Remote Control:
Command Executed

3.4 Manual Operation

Pressing the Switchover Pushbutton allows switching the SMSB10 BD locally without the need
of sending an SMS.
If set for pulse operation, pressing the Switchover Pushbutton switches the relay ON for the
programmed time.
No SMS acknowledgement is sent from the SMSB10 BD when using the Switchover
Pushbutton.
24
Explanation
User calls the SMSB10 BD.
SMSB10 BD sends the "Sample" SMS to the command
issuer.
Explanation
The relay switches.
The two-colour LED changes from red to green or vice-
versa.
The SMSB10 BD sends the acknowledgement SMS
or shown to the command issuer (if so configured—see
section 2.2).
Explanation
The relay switches ON for the programmed activation time
st
(1 telephone book entry).
The two-colour LED changes from red to green during the
programmed activation time and then back to red.
The SMSB10 BD sends this acknowledgement SMS to
the command issuer.
nd
entry in the SIM telephone book = 1),