Safety Instructions; Machine Information - VONROC MM501DC Traduction De La Notice Originale

EN

1. SAFETY INSTRUCTIONS

Read the enclosed safety warnings, the additional
safety warnings and the instructions. Save the
safety warnings and the instructions for future
reference.
The following symbols are used in the user manual
or on the product:
Read the user manual.
Denotes risk of personal injury, loss of life
or damage to the tool in case of non-obser-
vance of the instructions in this manual.
The product is in accordance with the
applicable safety standards in the European
directives.
GENERAL POWER TOOL SAFETY WARNINGS
• To operate this device safely, the user must
have read and understood these instructions for
use before using the device for the first time.
• Observe all safety instructions! Failure to do so
may cause harm to you and others.
• Retain all instructions for use, and safety in-
structions for future reference.
• If you sell or pass the device on, you must also
hand over these operating instructions.
• The device must only be used when it functions
properly. If the product or part of the product is
defective, it must be taken out of operation and
disposed of correctly.
• Beware of the sharp pins, they can cause per-
sonal injury or injury to others.
• Check calibration before use.
• Operate the device properly,conductive material
such as salts, carbon and metal can give false
positive readings.
Using battery-operated devices
• Only use batteries approved by the manufacturer.
• Danger of fire! Never charge the batteries.
• Keep batteries away from metal objects that
could cause short circuiting when not in use.
There is a risk of injuries and fires.
• Fluid can escape from the battery when used
incorrectly. Battery fluid may result in skin irri-
tations and burns. Avoid contact! In the event of
accidental contact, rinse thoroughly with water.
4
Immediately seek the aid of a physician in the
event of eye contact.

2. MACHINE INFORMATION

Intended use
The moisture meter is designed for use in wood-
working, water damage restoration, building con-
struction and home renovation. Examples include:
• Checking for moisture and mold on or below the
surface of carpets and subflooring;
• Measuring the moisture content of wood, dry-
wall or cement board before painting, wallpape-
ring, sealing or treating;
• Locating water leaks above ceilings, below
floors or behind walls;
• Selecting dry lumber, for example firewood.
Improper use may damage the tool.
TECHNICAL SPECIFICATIONS
Model no.
Measurement Ranges
Measurement Accuracy
Measurement Resolution
Calibration Check Range
Excessive-moisture alarm
levels
LCD Size
Bar Graph Composition
Auto Power Off Trigger
Low Battery Icon Trigger
Operating Temperature
Operating humidity
Storage Temperature
Storage humidity
Dimensions
Weight
Power Source
MM501DC
5 to 50% for wood
1.5 to 33% for building
materials
±2% for wood and building
material
0.1%
17.3% to 19.3%
>16% for wood
>20% for building materials
51mm diagonal, with three
13mm high digits
3 each green, orange and
red LEDs
1 minute of inactivity
<7V
0° to 40°C
<70%RH non-condensing
-10° to 50°C
5%~95% RH
(without battery)
174 x 70 x 74mm
150g without battery
(1) '9V' battery (included)
9V 6F22 or 6LR6
recommended
WWW.VONROC.COM