RC Logger RC EYE One S 88005RC Instructions D'utilisation page 35

Resetting the gyro flight leveling sensor
In case your "RC EYE One S" appears to be drifting in one direction, noticeable especially in beginner
mode, you may need to reset the sensor calibration. The drift in one direction after a short period of time
requiring adjusting the trim to regain stable flight where the "RC EYE One S"may start to drift again after
another short period of time may be related to the following two reasons:
1. A motor shaft might be slightly bent or a propeller is defective resulting in vibrations. Either replacing the
motor(s) or install a complete new set of propellers may solve this issue. Crashing the "RC EYE One S",
or exposing it to mechanical stress during transportation typically causes these phenomena.
2. The onboard sensor has lost its factory calibration. Typically this is caused by a hard hit, such as a
crash or repeated crashes, or exposure to high temperature. It could also be related to transport issues.
Mode 1
1. Place the "RC EYE One S" onto an as flat as possible level surface.
2. Power on the transmitter, while the flight battery is connected.
3. Move the throttle/aileron stick to bottom right position, and move the elevator/rudder stick fully up
vertically.
4. Hold the sticks at their positions until the transmitter sounds an acoustic signal and the "RC EYE One S"
status LED turns solid.
5. The calibration has been completed, no drift should be observed. In case the "RC EYE One S" still drifts,
the sensor may be defective or vibrations still remain. Please continue to replace all 4 motors until level
flight can be performed.
Mode 2
1. Place the "RC EYE One S" onto an as flat as possible level surface.
2. Power on the transmitter, while the flight battery is connected.
3. Keep throttle and rudder stick at zero and move the aileron / elevator (nick, roll) to full top right position.
4. Hold the sticks at this position until the transmitter sounds an acoustic signal and the "RC EYE One S"
status LED turns solid.
5. The calibration has been completed, no drift should be observed. In case the "RC EYE One S" still drifts
the sensor may be defective or vibrations still remain. Please continue to replace all 4 motors until level
flight can be performed.
35