Assembly Instructions - Fitting The Carrier On The Bicycle - Bobike one maxi Mode D'emploi

03. ASSEMBLY INSTRUCTIONS
FITTING THE CARRIER ON THE BICYCLE
1
K
Remove the frame holder (K) from the metallic support
bar (N). To do that, you should press the release button
(K3) and simultaneously pull the metallic support bar (N)
up.
3
K4
Place the front frame holder (K2) on the front bicycle frame. Insert 4 screws (K1) in the frame holder to tighten the rear frame
holder (K4), so that the height can be adjusted later. The correct positioning of the frame holder (K) is extremely important.
Make sure the frame holder (K) is positioned in the bicycle frame according to the picture (1).
2
N
K3
Unscrew the frame holder screws (K1). Use the key (H6).
Up
K2
5
H6
EN
K1
K1