Assembly Instructions Seating The Child On The Carrier - Bobike one maxi Mode D'emploi

SEATING THE CHILD ON THE CARRIER
16
B3
To put the child into the carrier you must first loosen the
retention system harness. First, extend the belt straps (B3)
to the maximum by pressing the upper strap adjustment
button (B2), then pull it up. This will simplify the
placement of the retention system harness (B) when the
child is in the child carrier. We recommend that the child's
helmet must be placed on after the retention system
harness is adjusted.
18
B3
Next adjust the retention system harness (B) to the size of
the child to ensure that the child is firmly secured. First
adjust the height of the retention system harness (B). To
do this, pull the belt straps (B3) according to the size of
the child. Before starting the journey, always check that
the child is secured and that the retention system harness
is snug but not so tight that it hurts the child.
04. ASSEMBLY INSTRUCTIONS
B2
B2
17
M2
To place the child in the child carrier, first undo the
retention system harness. Start by pressing the releases
on the sides of the safety buckle (M1) and pull the safety
buckle (M) upwards, so that it slides out of the socket
(M2). Place the child in the child carrier. lnsert the safety
buckle (M) in its socket again (M2). Make sure that the
buckle socket (M2) is correctly positioned and does not
hurt the child.
19
To complete this step and ensure that the child is safe,
adjust the lower lap belt adjuster (B4) according to the
size of the child, sliding it up or down.
11
EN
M1
B4