Fame Audio MSW Pro 1 Vocal Mode D'emploi page 15

MSW Pro Hand Transmitter
13. Battery compartment (2x AA)
14. On/Off-Switch
1. Switch on the receiver via the On/Off Switch (1).
2.
Switch on the Hand transmitter via the On/Off Switch (14).
3.
Connect the transmitter to the receiver.
a) Select the desired channel (8) (only MSW Pro 2 and 4) to be controlled.
b) Press the Scan button (7) on receiver to search for a free frequency. "Scan ok" is
displayed once search is complete.
c) To connect the hand-held transmitter to the receiver, press the receiver's IR sync
button (6) while aligning the handset (15) and the receiver (4) to each other. After
successful synchronization the display of the hand transmitter (16) flashes and the
display of the receiver (2) shows „sync ok".
4.
Connect your receiver to your mixing console. Here you have two options:
a) Connect your receiver via the 1/4 „jack mix output (10) to get a sum signal of all
channels (MSW Pro 2/4).
b) Connect your receiver via the XLR outputs (12) (Balanced) to control each channel
(MSW Pro 2/4) individually.
5. Set your desired output volume via the respective channel volume controller (5) of the
receiver.
15. IR Interface
16. LCD Display
Operation
15