Important Instructions; Security Advice - Nauta Basic Série Manuel D'utilisation

USER MANUAL ELECTRONIC LOCK BASIC

1. Important instructions

1.1 Code entry
The electronic lock operates with a six digit code. You can programme a second opening code. Each input is
confirmed by a beep and the light illuminates.
After entering a valid code, a double signal sounds. If the code is an invalid code, you will hear a long beep. If you
wait more than ten seconds, the entered code disappears and you have to enter it again.
1.2 Opening the safe
Enter the six digit code (factory code 123456) and unlock the door within three seconds using the handgrip or
knob. If you do not open the lock within three seconds, the lock closes again automatically.
1.3 Closing the safe
Close the door and turn the handle or knob into the closed position. The lock is automatically locked. You can
test whether the lock is locked by turning the handle to the open position.
1.4 Blocking
If incorrect codes are entered four times in a row, the keypad blocks automatically for five minutes. The light
flashes every ten seconds during this period. And if you try to use the keypad, you will hear a long signal. Entering
a wrong code twice after the blocking period ends will start a new delay time of five minutes.

1.5 Security advice

Once you start using the safe, change the standard factory code into your own personal access code
immediately. When choosing a code, avoid obvious combinations such as numbers related to your birth date,
part of your telephone number or postcode. Remember the code and keep it to yourself. If you feel the need to
write it down, keep it in a safe place.
14
!