Error Codes; Loudspeaker Connection - RCF ES3160 Manuel D'utilisation

ERROR CODES

ERR-1 and ERR-2
ERR-3
ERR-4

LOUDSPEAKER CONNECTION

Use 1 output only – DO NOT MIX 100 / 70 V and 4 Ω CONNECTIONS.
70 / 100 V CONSTANT VOLTAGE OUTPUTS
POWER OUTPUT
COM 70V 100V
0 100V 0
•
•
POWER OUTPUT
COM 70V 100V
44
Push and hold (at least 2 seconds) the
disc. If the CD is not ejected, push the
y
EJECT (2 seconds) again.
Should not be possible to eject the CD, please consult your dealer (or an
authorized service centre).
The compact-disc has been wrongly inserted upside down.
The compact disc format is not supported (or data / files are not correct).
100 V
100V 0 100V
Each loudspeaker shall have a line transformer with the input voltage equal to the line voltage
(70 / 100 V).
The loudspeaker total power shall not be higher than the amplifier maximum power.
LOW IMPEDANCE OUTPUT (4 Ω)
•
The loudspeaker total impedance shall not be lower than 4 Ω.
Note:
a total impedance equal to 4 Ω allows the amplifier maximum power
delivery. A higher impedance leads to a reduction of the power delivered
by the amplifier (e.g. 8 Ω: approx. ½ power, 16 Ω: approx. ¼ power). An
impedance lower than 4 Ω overloads the amplifier.
•
Loudspeaker models shall be chosen by considering the max. power
(160 W on a 4 Ω load) that the amplifier can deliver.
•
Loudspeaker line should be as short as possible, long cables may need
large wire cross-sections.
•
Do not use, at the same time, both the low impedance output (4 Ω) and the
constant voltage output (70V or 100V), as this overloads the amplifier.
y
EJECT button to eject the compact
t
RESET button by using a pin and then
POWER OUTPUT
COM 70V 100V
0 70V 0
70 V
70V 0 70V