Troubleshooting - Conrad MC Crypt UHF-2032 Notice D'emploi

Troubleshooting

By purchasing the complete radio microphone set, you have acquired a product which has been designed to the state
of the art and is operationally reliable. Nevertheless, problems or faults may occur. Therefore, we would like to
describe how to eliminate possible faults here:
Please observe the safety instructions!
Device does not work after the POWER switch (2) has been switched on.
• The power pack unit has not been plugged into the socket correctly
• The power unit connection line is properly connected to the device's DC IN (13) socket.
• The mains socket is not supplied with power.
The display in the POWER switch (2) at the receiver is lit, but no sound can be heard:
• The receiver is not properly connected to the subsequent audio device.
• The wrong input is used at the subsequent audio device.
• The microphone/s is/are not switched on.
• The microphone batteries are flat.
• The volume control at the receiver or the subsequent audio device is set incorrectly.
There is some interference with the radio transmission or there is no reception.
• There is a strong source of interference (e.g. radio devices, computer, strong electric motors) in the vicinity of the
microphones or receiver.
• There are radio wave barriers in the transmission path (metal surfaces, reinforced concrete walls, etc.).
• The range of the system has been exceeded.
• The microphone batteries are flat.
• Another radio-based device interferes with transmission. Try another channel setting.
• The aerials are not ideally aligned. Try realigning the aerials.
30