First Installation; Wireless Connection Of Zones (Pairing) - Fenix V24 WIFI Guide D'utilisation

2

First Installation

When connecting the central unit for the first time,
aside from the setting of basic parameters, it is also
necessary to provide a power supply for the V24 WIFI
central unit for a period of least 24 hours in order for
the back-up source to reach maximum capacity.
First operation after power up is to change the
language.
Choose the language by clicking to the required
language. The selected language is highlighted (blue
frame)
After making the selection, press the arrow at the left
bottom corner (forwards) to validate the selection.
2.1

Wireless connection of zones (pairing)

In order to easily pair your V24 WIFI central unit with
other regulation elements of the heating system you
have to install and connect the regulation members
first (usually a V22 thermostat with a V23/25
receiver/receivers) in all the rooms/zones (usually, one
room = an independent zone). Only afterwards should
you start pairing your central unit with the individual
zones.
Press "Settings" button.
2.1.1
Press the "Pairing" button
2.1.2
Press the "New Heating Zone" / "New
2.1.3
ON/OFF Zone" button
Press "New Heating Zone", if a Heating zone has to be
paired or press "New ON/OFF Zone" if it is about an
ON/OFF Zone.
2.1.4 Display now shows the button to start
pairing
Choose the zone number you want for this zone.
Now switch the main receiver (usually a V23
thermostat) in the given room/zone to the "RF init"
mode by pressing the pairing button for a period of 3
seconds – the LED diode on the paired unit will glow
green.
Important:
Only the master receiver in a group – the Master to
which other regulation members in the zone are
connected – may be linked to the central control
unit.
To pair a receiver, press the "Pairing"
2.1.5
button on the central unit
3