Product Features - HP Autozubehor Smart 6 Manuel D'utilisation

• Have plenty of fresh water and soap nearby in case battery acid contacts skin.
• If battery acid contacts skin or clothing, wash immediately with soap and water for at
least 10 minutes and get medical attention immediately.
• Never smoke or allow a spark or flame in vicinity of vehicle battery, engine or battery
charger.
• Remove personal metal items such as rings, bracelets, necklaces and watches when
working with a lead acid battery. A lead acid battery can produce a short circuit current
high enough to weld a ring, or the like of a metal, causing a severe burn.
• Never allow battery acid to come in contact with this unit.
• Do not operate this unit in a closed area or restrict ventilation in any way.
FIRST AID – SKIN:
If battery acid comes in contact with skin, rinse immediately with water, and then wash
thoroughly with soap and water. If redness, pain, or irritation occurs, seek immediate
medical attention.
• FIRST AID –EYES:
If battery acid comes in contact with eyes, flush eyes immediately, for a minimum of 15
minutes and seek immediate medical attention.

PRODUCT FEATURES

• For all 6V and 12V lead acid batteries (WET, MF, AGM and GEL);
• Charging voltage auto select;
• Charging current selection;
• No risk of over charging;
• Electronically safe against user error with LED indicator;
• Spark proof;
• Over heat protection;
• Full protected against short circuit and wrong connections;
• With LED indicators;
12V battery recovery
For 12V batteries voltage lower than 8V, you can use the charger to recover the battery.
Recovery Operation Steps:
1. Plug in the AC power without the connection with the battery;
2. Press the MODE button for 3~5 seconds until the 12V LED indicator comes on;
3. Now connect the output clamps/terminal rings with the battery correctly;
4. The charger begins charging with 1.5A low current to recover the battery, which
terminates when the voltage reaches to 10.5V ± 0.25V, and then it switches over
to regular charging mode.
OPERATING INSTRUCTIONS
1. Connecting the terminal rings/clamps directly to the corresponding connectors on the
battery posts.
Note:
8/26