GE APPLIANCES PFD87 Guide De L'utilisateur Et Instructions D'installation page 8

Getting started
D Drying
Cycles
TIMED DRY
Settings
E
Individual settings for cycle minutes (Time), dryness level (Level) and temperature (Temp) can be set from the
minimum (lowest in column) to maximum (highest in column). In general, the higher up the column, the more
energy will be used. NOTE: The selected cycle set Time can be further adjusted, in one minute increments, by
pressing the More Time + and Less Time - pads.
Dryness Level - Selection only used for Sensor cycles. Timed cycles run for the selected time.
NOTE: Options for Dryness Levels vary by model. Refer to the control panel on your model or to the control
panels shown earlier in this manual.
Extra Dry Use for heavy-duty fabrics or items that should be very dry, such as towels.
More Dry Use for heavy-duty or mixed type fabrics.
Dry Use for a normal dryness level suitable for most loads. This is the preferred cycle for energy
Less Dry Use for lighter fabrics.
Damp For leaving items partially damp.
Temperature
High For regular to heavy cottons.
Medium For synthetics, blends, delicates and items labeled permanent press.
Low For delicates, synthetics and items labeled tumble dry low.
Extra Low For lingerie and special-care fabrics.
No Heat For fluffing items without heat. For use only with the AIR FLUFF cycle.
8
Sensor cycles automatically determine fabric dryness.
Timed cycles run for the selected time.
Use to set your own dry time. To use:
1. Turn cycle dial to TIMED DRY.
2. Increase the drying time by pressing the Time pad.
NOTE: This pad only increases the time. When max time is reached, pressing the pad again
will reset the counter to the lowest setting.
3. Select the Temp.
4. Close the door.
5. Press Start/Pause pad.
savings.
NOTE: STEAM Dewrinkle and STEAM Refresh require the High temperature setting.
49-3000386 Rev 0