SilverCrest SND 4600 A1 Mode D'emploi page 21

Colour and brightness settings
♦ Adjust the colours and brightness as required by clicking on the
"Color/Brightness Adjustment" button (K).
♦ Move the "Brightness" slider to set the brightness between
0 and 255.
♦ Move the three "Color Balance" sliders to set the RGB values
between 0 and 255.
♦ To reset to the default values, click on the "Reset" button.
After use
♦ Remove the negative holder
the device.
♦ Remove the slide magazine
4
slot on the right.
♦ Remove the USB cable
and the scanner.
SND 4600 A1
5
by pushing it all the way through
6
by pulling it back out of the
8
from the USB port on your computer
GB │ IE │
17 ■