Black & Decker BDCD8 Instructions Originales page 8

ENGLISH
• Insert the charger plug (5) into the USB
charging port (4) as shown in figure A.
The charging indicator (6) will be lit,
indicating that the battery inside the drill
is being charged. When charging is
completed the light (6) will turn off.
• Let the tool charge initially for 9 hours.
After the initial charge, under normal
usage, your tool should be fully charged
in 8 to 9 hours.
Warning! Do not use tool while it is
connected to the charger.
Warning! fire Hazard. When disconnecting
the charger from the tool, be sure to unplug
the charger from the outlet first, then
disconnect the charger cord from the tool.
Trigger switch & reversing button (fig. B)
• The drill is turned ON and OFF by pulling
and releasing the trigger switch (1)
• A forward/reverse control button (2)
determines the direction of the tool and
also serves as a lock off button.
• To select forward rotation, release the
trigger switch and depress the
forward/reverse control button to the
left.
• To select reverse, depress the forward/
reverse control button the opposite
direction.
• To lock the tool, set the forward/reverse
slider into the centre position.
Note! The center position of the control
button locks the tool in the off position.
When changing the position of the control
button, be sure the trigger is released.
Keyless chuck (fig. C)
Warning! Make certain the lock-off button is
engaged to prevent switch actuation before
installing or removing accessories.
To insert a drill bit or other accessory:
• Grasp the rear half of the chuck (7) with
one hand and use your other hand to
rotate the front half (8) in the
counterclockwise direction, as viewed
from the chuck end.
8
All manuals and user guides at all-guides.com
(Original instructions)
• Insert the bit or other accessory fully into
the chuck, and tighten securely by
holding the rear half of the chuck and
rotating the front portion in the clockwise
direction as viewed from the chuck end.
Warning! Do not attempt to tighten drill bits
(or any other accessory) by gripping the
front part of the chuck and turning the tool
on. Damage to the chuck and personal injury
may occur when changing accessories.
Drilling/screwdriving
• Select forward or reverse rotation using
the forward/reverse slider (2).
• To switch the tool on, press the switch (1).
The tool speed depends on how far you
press the switch.
• To switch the tool off, release the switch.
Hints for optimum use
Drilling
• Always apply a light pressure in a straight
line with the drill bit.
• Just before the drill tip breaks through
the other side of the workpiece, decrease
pressure on the tool.
• Use a block of wood to back up
workpieces that may splinter.
• Use spade bits when drilling large
diameter holes in wood.
• Use HSS drill bits when drilling in metal.
• Use masonry bits when drilling in soft
masonry.
• Use a lubricant when drilling metals other
than cast iron and brass.
• Make an indentation using a centre punch
at the centre of the hole to be drilled in
order to improve accuracy.
Screwdriving
• Always use the correct type and size of
screwdriver bit.
• If screws are difficult to tighten, try
applying a small amount of washing liquid
or soap as a lubricant.