Publicité
Les langues disponibles
Les langues disponibles
en-US
Connecting the wall bracket
(Figs. 21 + 22)
Slide the wall bracket down into the
mounting plate from above until it au-
dibly clicks into place (Fig. 21).
Slide the PowerUnit of the fully as-
sembled vacuum cleaner, with the
battery inserted, down into the wall
bracket from above (Fig. 22).
Plug the charger into the power
socket.
The charging process will start.
Battery charging state indicator
(while charging) (Fig. 23)
The battery charging state is displayed
on the PowerUnit.
Battery life
Approx. 0–34%
Approx. 35–69% Bottom light is lit
Approx. 70–90% Bottom and middle
Approx. 91–99%
100%
Once the battery is fully charged, the
battery charging state indicator
switches off to conserve energy.
176
Indicator
Bottom light
flashes slowly
up; middle light
flashes slowly
lights are lit up; top
light flashes slowly
Bottom, middle,
and top lights are
lit up
Switches off
If the battery has not been used for a
long time and has run down, it will go
into safe mode. As a result, the battery
charging state indicator will only re-
spond after approximately 30–60 min-
utes when charging in the PowerUnit.
Battery charging state indicator
(while in use) (Fig. 23)
The battery charging state is displayed
on the PowerUnit.
Battery life
Approx. 100–70% Top, middle, and
Approx. 69–35%
Approx. 34–15%
Approx. 14–0%
We recommend allowing the battery to
run down completely before recharging
it. In this way, you will benefit from the
battery's full capacity.
Indicator
bottom lights are
lit up
Middle and bot-
tom lights are lit
up
Bottom light is lit
up
Bottom light
flashes slowly
Publicité
