Philips AZ 1008 Mode D'emploi page 15

All manuals and user guides at all-guides.com
Problem
No sound
Power cord not securely
connected
Batteries dead /incorrectly
inserted
Display does not function
properly/ No reaction to
operation of any of the
controls
Er indication
CD badly scratched or dirty
Laser lens steamed up
CD-(R) is blank or the disc
is not finalized
CD playback does not work
The CD skips tracks
Poor cassette sound quality
Recording does not work
If a fault occurs, first check the points listed below
before taking the set for repair. Do not open the
set as there is a risk of electric shock.
If you are unable to remedy a problem by following
these hints, consult your dealer or service center.
WARNING: Under no circumstances should you try
to repair the set yourself, as this will invalidate the
warranty.
Solution
– Adjust the VOLUME
– Connect AC power cord properly
– Insert (fresh) batteries correctly
– Electrostatic discharge
– Switch off and unplug the set. Reconnect after a few
seconds.
– No CD inserted, insert a CD
– Replace/ clean CD, see Maintenance
– Wait until lens has cleared
– Wait until lens has acclimatized
– Use a finalized CD-(R)
– CD badly scratched/ dirty. Replace/ clean CD (see
maintenance)
– CD damaged or dirty. Replace or clean CD.
– Program is active. Quit program mode
– Dust and dirt on the heads, etc.
Clean deck parts, see maintenance.
– Use of incompatible cassette types (METAL or
CHROME). Only use NORMAL (IEC I) for recording
– Cassette tab(s) may be broken. Apply a piece of
adhesive tape over the missing tab space.
Troubleshooting
15