To Start The Engine; To Operate The Product - Husqvarna Rider 322T AWD Manuel D'utilisation

To lower the cutting deck to mowing position, press the
lock button and move the lift lever forward. If the engine
is running, the blades start to rotate automatically.

To start the engine

1. Make sure that the drive system is engaged, see
engage and disengage the drive system on page 15 .
2. Lift up the cutting deck and apply the parking brake.
3. Turn the ignition key to the start position.
16
To
2
1
4. When the engine starts, immediately release the
ignition key to neutral position.
Note: Do not run the starter for more than 5 seconds
at a time. If the engine does not start, wait 15
seconds before you try again.
5. Turn the key to the lights position to make the
headlights come on.
6. Let the engine run at half throttle (B) for 3-5 minutes
before you apply heavy load.
7. Push the throttle control to full throttle position (C).
A
Note: To engage the blades when the engine is at full
speed causes strain on the drive belts. Do not apply full
throttle until the cutting deck has been lowered to the
mow position.

To operate the product

1. Start the engine.
B C
270 - 001 - 28.11.2017