Connecting To The Rest Of The System - Pioneer PDR-F10 Mode D'emploi

Connecting to the rest
of the system
The PDR–F10 connects directly to the XC–
F10 CD tuner. If you're setting the whole
system up for the first time, be sure to also
refer to chapter 2 of the XC–F10 manual for
full installation and connection details.
Important: Before making or changing
any connections, make sure that all the
components are switched off and unplugged
from the power supply.
There are two connections to make: a ribbon
cable and an optical cable for digital audio.
1 Pull out the protective tabs from
the optical jacks of the CD tuner
and CD recorder.
2 Thread the cables through Stand
A, then connect the optical cable
from the CD tuner to the CD
recorder.
PDR-F10
All manuals and user guides at all-guides.com
Stand A
2 Connecting up
3 Slot Stand A on to the rear side of
the unit.
Line up the three tabs on the stand with the
holes on the back of the unit, then slot it into
place.
4 Connect the other end of the
ribbon cable to the CD tuner unit.
It's much easier to connect the ribbon cable if
Stand A is not attached. However, remember
that the cables must be threaded through the
stand for it to be attached. (The ribbon cable
can pass under the Stand A to keep it tidy.)
CD tuner
Stand A
Stand A
9
En